FAAC Gate Repair Nationwide | Gatewood Fence & Gate

FAAC Gate Repair in Granada Hills: What to Know First

Independent FAAC gate repair in Granada Hills runs $185-$640 on most jobs, and we can usually have your gate working again within 24 to 48 hours of the first call. That’s the honest range we’ve seen across the 99244 zip code and the surrounding north Valley neighborhoods. You’re not paying for a truck wrapped in corporate branding or a technician who’s never touched a FAAC board before. You’re paying for the repair itself, and the price is quoted and agreed before any work starts.

Call (760) 361-6706

If you own a FAAC swing or slide gate in Granada Hills and it’s grinding, stalling mid-cycle, or refusing to respond to the remote, this page is for you. We’re Gatewood Fence & Gate, and we’ve been fixing these specific units since 2001. Call (760) 361-6706 and a live person answers, any hour.

How FAAC Products Fail - and How We Fix Them

• FAAC 402 and 412 operator capacitor failure. These compact swing operators are common on Granada Hills single-family gates, and when the start capacitor dies, the motor hums but won’t move the leaf. It’s almost never a bad motor. We test the capacitor first, replace it with the correct microfarad rating, and you save $300-$500 versus a full operator replacement. This is a specific diagnosis we make weekly in Granada Hills - hot summers age capacitors faster than anything else.
• FAAC S418 and S450 slide gate limit switch drift. The S418 is a workhorse on long driveway slide gates in Granada Hills, but its mechanical limit switches shift over time, so the gate overruns the closed position and slams into the end stop. Or it stops three feet short. We reset and lock the limits, then run a full open/close cycle test. If the nylon limit cams are stripped, we replace them with OEM-spec parts rather than letting the gate hammer itself until the gearbox fails.
• FAAC E024U and E024S control board phantom faults. These boards log error codes that often don’t match the actual problem. A “photocell fault” on the display can actually be a bad edge sensor or a loose terminal strip. We don’t clear codes and call it done - we trace the wiring, check resistance, and confirm the board is actually receiving clean inputs. Swapping a $500 board without checking the wiring is exactly the kind of sloppy work we get called in to correct.
• FAAC hydraulic operators with low fluid or leaking seals. FAAC’s hydraulic swing operators, like the 770 and 400 series, hold up in Granada Hills, but when they get slow in winter or sag before opening, it’s usually fluid level or a weeping seal at the piston. We inspect the ram, top off with the correct hydraulic fluid, and replace seals when needed. A hydraulic operator that runs low on fluid will burn out the pump, and that’s a $1,200 mistake we’d rather help you avoid.
• FAAC photocell and safety edge misalignment on hillside driveways. Granada Hills driveways have real grade to them, and a FAAC gate on a slope moves differently than one on flat ground. The safety edge on the bottom of the leaf can catch on uneven concrete or gravel, and the photocells drift out of alignment seasonally as the ground settles. If your FAAC gate reverses for no reason or won’t close at all, this is where we start - not by blaming the board.

Our FAAC Gate Repair Process

1. 1
   You call, a person answers. You tell us what the gate is doing, or not doing. Hal can usually narrow it down over the phone - “Tell me what it’s doing and I’ll tell you what it needs - no runaround.”
2. 2
   We show up when we say we will. No four-hour windows. We arrive in a marked vehicle, introduce ourselves, and put eyes on the gate before quoting anything.
3. 3
   Diagnosis before parts. We test the operator, board, transformer, and safety devices in that order. If it’s a wiring fault, we’ll show you the bad connection. If it’s a ol2 capacitor, that’s what we replace.
4. 4
   Parts decision, made with you. For FAAC jobs, we use OEM parts where it matters for reliability - boards, gearboxes, safety edges - and quality aftermarket where it makes no functional difference, like capacitors, remote receivers, and minor hardware. We tell you the difference in cost and let you decide.
5. 5
   The repair, done in your driveway. We weld on site when needed, whether it’s a cracked hinge bracket or a broken wheel carriage on a slide gate. The gate doesn’t get hauled off to a shop.
6. 6
   Test, clean up, and the 90-Day Done Right Promise. We cycle the gate multiple times, check the safety devices under load, and walk you through what we did. Every job carries our written promise: if it’s not done right, we make it right.

What FAAC Gate Repair Costs in Granada Hills

Here’s what we see across Granada Hills FAAC service calls, based on parts and labor for standard single and double swing or slide gates:

• Capacitor or fuse replacement: $185-$260
• Photocell realignment or replacement: $145-$225 per set
• Limit switch adjustment or replacement: $190-$310
• Control board diagnosis and repair (no new board): $225-$375
• Control board replacement (FAAC E024U or similar): $450-$640 installed
• Hydraulic seal or fluid service: $260-$420
• Hinge or post weld repair (on site): $300-$550 depending on access and steel condition

The price you’re quoted is the price you pay - no surprise line items at the door. Two things move FAAC costs in Granada Hills: whether the board is genuinely dead versus repairable, and how much of the gate’s metal has been neglected. We’ll show you the damage and quote before we touch a bolt. Estimates are free, and there’s no trip charge inside the county.

Why Granada Hills Homeowners Call Gatewood Fence & Gate for FAAC Work

We’ve been at this since 2001, and the name on the shop is Hal Gatewood’s. That means when a FAAC gate in Granada Hills fails at 7 p.m. on a Thursday, the person answering the phone is someone who can actually help you - not a script-reader in another state. Our crew knows FAAC boards, operators, and hydraulic units because we’ve opened hundreds of them. We’re also certified to service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so if you have a second gate on the property with a different brand, we handle it without blinking.

Every FAAC repair carries the 90-Day Done Right Promise in writing. Not “up to” anything. Not “in most cases.” If it’s not done right, you call, and we’re back. That’s the oldest accountability there is, and it’s the same accountability that kept Hal’s schedule full when Granada Hills was still getting to know us.

FAQs