Ghost Controls Gate Access Control Nationwide | Gatewood Fence & Gate

Ghost Controls Gate Access Control in Granada Hills: What to Know First

We service Ghost Controls gate access control systems throughout Granada Hills, and most repairs are finished the same visit. A keypad that won’t accept codes, a remote that only works from ten feet away, a phone entry system that rings but won’t release the gate – these are the calls we run every week, and we quote the price before any work starts, not after. If you own a Ghost Controls opener in Granada Hills and the access side is acting up, call (760) 361-6706 and you’ll get a live person, not a recording. Hal Gatewood has been fixing gates in this area since 2001, and most of what we see on Ghost Controls systems is fixable without replacing the whole setup.

Call (760) 361-6706

How Ghost Controls Products Fail - and How We Fix Them

• AXDP keypads losing code memory. The Ghost Controls AXDP keypad is a solid unit, but we see a pattern in Granada Hills where the keypad forgets its codes after a power blip or a battery change. The cause is usually a cheap aftermarket battery someone swapped in, or corrosion on the battery contacts from our dry heat cycling. We clean the contacts, install the right battery, and reprogram the codes so they actually hold.
• Receivers going deaf on the TSS1 and TDS2 openers. The most common Ghost Controls complaint we get is “the remote stopped working unless I’m right next to the gate.” On the TSS1 and TDS2 lines, the receiver board sits close to the motor and picks up electrical noise over time. We replace the receiver module with a quality part, relocate the antenna where it belongs, and most customers get their original range back.
• Wire-loop vehicle exits that won’t trigger. Ghost Controls systems love a good inductive loop for automatic exit, but in Granada Hills the soil shifts with heat and the loop wire develops breaks or shorts at the saw-cut. The symptom is a gate that opens fine with the remote but won’t respond when you drive over the loop. We test the loop with a meter, find the break, and repair or re-cut it – no new opener needed.
• Intercom and phone entry modules dropping calls. When a Ghost Controls gate is paired with a phone entry module, we often find the problem isn’t the Ghost Controls board at all – it’s a degraded phone line or a cellular module that lost its signal. We trace the actual fault before quoting anything, because replacing a control board when the carrier dropped signal is a waste of your money.
• Photoelectric sensors misaligned after a wind event. Ghost Controls photoelectric safety eyes are durable, but the Santa Ana winds we get through the Valley can flex a gate post just enough that the beam no longer lines up. The gate then refuses to close, or reverses halfway. We square the sensor mounts, check the post for true, and reset the travel limits so the gate doesn’t fight itself.

Our Ghost Controls Gate Access Control Process

Here’s what happens when you call us about a Ghost Controls access problem in Granada Hills:

1. 1
   You call, a person answers. Not a robot, not an answering service. You describe what the gate is doing – or not doing – and we give you a straight answer about whether it sounds like a service call or something you can check yourself.
2. 2
   We show up on time. Hal or one of his crew arrives with Ghost Controls parts on the truck, plus the diagnostic tools to test the board, the receiver, the keypad, and the power supply.
3. 3
   We test before we touch. We don’t start swapping parts hoping to get lucky. We find the actual failure first – bad board, bad sensor, bad wire, bad ground – and then we show you what we found.
4. 4
   Parts decision, made with you. Where OEM Ghost Controls parts make sense, we use them. Where a quality aftermarket part does the job at half the price and won’t void your setup, we tell you that too. The price is agreed before work starts, in writing.
5. 5
   The fix, the test, the cleanup. We make the repair, run the gate through twenty cycles, test every access point – keypad, remotes, phone entry, sensors – and leave your driveway cleaner than we found it.
6. 6
   90-Day Done Right Promise. If it’s not done right, one call brings us back. The name on the invoice is Hal Gatewood, and the shop is down the road.

What Ghost Controls Gate Access Control Costs in Granada Hills

Here’s what Granada Hills homeowners can expect for common Ghost Controls access work:

• Keypad replacement or reprogramming: $95 to $240, depending on whether we’re fixing the existing keypad or installing a new AXDP unit.
• Receiver board or antenna repair: $140 to $310. If the receiver has failed completely, a new module runs higher.
• Photoelectric sensor realignment or replacement: $110 to $260 per pair.
• Phone entry or video intercom integration: $300 to $700, depending on the module and whether we’re running new wire or working with existing.
• Full access control retrofit (keypad, receiver, sensors, and programming): $500 to $1,100 for a single residential gate.

The price moves on three things: what actually failed, whether we’re using OEM or quality aftermarket parts, and how much wire work the job needs. We don’t charge a trip fee inside the county, and the quote is locked before we start. Call (760) 361-6706 for a free estimate on your Ghost Controls system – and don’t forget, we offer $40 off any repair over $200, plus a permanent 10% discount for seniors and veterans.

Why Granada Hills Homeowners Call Gatewood Fence & Gate for Ghost Controls Work

Most of our Ghost Controls customers in Granada Hills are people who already went through the wringer with an outfit that quoted one number on the phone and showed up with another. We don’t do that. We’re an independent Ghost Controls service provider – not a franchise, not a call center. Hal Gatewood’s name is on the shop, his address is published, and he’s the one who answers when something isn’t right. We also service LiftMaster, Mighty Mule, and DoorKing, which matters when a customer has a mixed property – a Ghost Controls gate opener with a LiftMaster keypad, or a DoorKing swing arm on the driveway gate. We fix what’s broken and leave what isn’t. Twenty-nine years in the Valley, still owner-operated, still answering the phone.

FAQs