Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterLinear Gate Repair in Granada Hills: What to Know First
We fix Linear gate openers and operators in Granada Hills, usually within one to two business days of your call. As an independent Linear service provider, we don’t sell you parts you don’t need and we don’t quote one price on the phone and a different one when we arrive. The price is agreed before we touch anything, and every repair carries our 90-Day Done Right Promise in writing. If you’re in Granada Hills and your Linear gate is grinding, stopped mid-cycle, or refuses to close, call us at (760) 361-6706 and tell us what it’s doing. We’ll tell you what it needs.
How Linear Products Fail - and How We Fix Them
- Linear LRA and LSO series swing operators: capacitor failure after valley summer heat. We see this all over Granada Hills every year when temperatures push past 100 for consecutive days. The start capacitor in the LSO swing arm gives out and the operator just hums without moving the gate. It’s a $40 part and an hour of labor, but we’ve watched other companies quote a whole new operator for it. We test the capacitor first, replace it with an OEM-spec unit, and you’re done the same visit.
- Linear SLR slide gate operators: stripped drive gears from a gate that’s out of track. The SLR gear train is tough, but it can’t fight a gate wheel that’s jumped the rail or a chain that’s gone loose. The motor starts ripping teeth off the drive gear, and then you’re paying for a motor gear plus the underlying track work. We check the rail alignment and chain tension on every SLR job, because replacing the gear without fixing what caused the failure just means buying a new gear next season.
- Linear ACT and ACP series keypads and controls: SW1 and SW2 dip switch drift. Older Linear keypads and receivers are famous for losing their codes when the dip switches vibrate loose or corrode. In Granada Hills, where gates sit a few miles off the 118 and everything gets a fine layer of dust, those little switches get gritty. Nine times out of ten the opener still works fine. We pull the cover, clean the switches, reset the code, and you keep the hardware you already paid for.
- Linear MDR and MDCS photoelectric sensors: misalignment shutdowns. These sensors were never designed for a post that shifts every winter when the ground around Granada Hills swells from rain. The gate will open fine and then refuse to close because the eye pairs have drifted a few degrees apart. We remount and realign the sensor brackets, then run the gate through ten full cycles to prove they hold alignment before we leave.
- Linear APeX controller boards: voltage regulator burnout from dirty power. The APeX board is where Linear packed a lot of very good logic into a very small space, and it does not tolerate voltage spikes. We see burned voltage regulators regularly on homes in the older Granada Hills neighborhoods where the electrical service predates modern surge rules. We replace the regulator and add a small surge protector in the operator cabinet, which costs you about a fourth of what a new control board runs.
Our Linear Gate Repair Process
- 1
You call, a person answers. It’s us, not an answering service. You tell us what the gate is doing and what brand it is. We ask for a photo if you can send one.
- 2
We show up on the day we promised. Hal or one of his background-checked, uniformed crew drives to your Granada Hills property and starts with a full inspection, not a quick listen and a quote.
- 3
We find the actual failure. No parts get replaced until we’ve traced the problem to its source. On a Linear, that often means testing limits, the board’s error codes, and the physical track and hinge condition, not just assuming it’s the motor.
- 4
We give you a straight price before we touch a tool. If the repair is over $200, you get $40 off right there. If you have a written estimate from someone else, we’ll give you a second opinion free.
- 5
We fix it with OEM-spec or quality aftermarket Linear parts. We use genuine Linear parts when availability and your budget support them, and when we use aftermarket, we tell you and explain the difference before ordering.
- 6
We test, cycle, and stand behind it. Full open/close cycles, reverse sensitivity check, photo eye alignment verified. Then we walk you through what we did and hand you the 90-Day Done Right Promise in writing.
What Linear Gate Repair Costs in Granada Hills
Most Linear gate repairs in Granada Hills run between $180 and $650 depending on what failed. Here’s what we typically see:
- Capacitor replacement (LSO/LRA swing operators): $180-$250 total
- Limit switch or travel module fix: $175-$320 total
- Photo eye realignment or replacement: $150-$285 total
- Drive gear replacement (SLR slide operators): $320-$550 total
- APeX control board replacement: $390-$650 total
- Full operator swap when repair truly won’t work: $900-$1,800 installed, quoted before any order
What moves the price is parts availability, gate weight and size, and whether there’s underlying post or track damage we have to address before the operator will hold up. You’ll always know the number before we start. Estimates are free, and the 10% senior and veteran discount applies to the labor on any repair. Call (760) 361-6706 for a straight answer on your specific Linear setup.
Why Granada Hills Homeowners Call Gatewood Fence & Gate for Linear Work
Hal Gatewood’s name has been on this shop since 2001, and the shop is down the road from the neighborhoods we work in. When we say we’ll be there, you’ll see the truck. When we say a repair will hold, it holds, or we come back under our 90-Day Done Right Promise and make it right. We work on Linear every week, but we also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so if your opener is a Linear but the keypad or receiver was swapped to something else along the way, we’re not scratching our heads. We answer the phone at 2 in the morning, we weld brackets and hinges on site instead of hauling your gate to a shop, and we don’t push a replacement when a repair will give you years more service. The price you hear is the price you pay, and the person who shows up knows exactly what he’s looking at. Tell me what it’s doing and I’ll tell you what it needs - no runaround.
FAQs
We typically schedule Linear repairs in Granada Hills within one to two business days, and we call you with a two-hour arrival window the morning of. If you have a gate stuck open or a security concern, tell us when you call and we’ll do everything we can to move your job up. Call (760) 361-6706 to see how soon we can get to your Granada Hills property.
We use genuine Linear parts whenever they’re available and they fit your budget, and we tell you before ordering if a quality aftermarket part is a better value for the age of your operator. On older Linear units, we typically match OEM specifications for capacitors, gears, and boards. Nothing goes in without your sign-off on the part and the price.
If your Linear opener is still under the manufacturer’s warranty, using an independent service provider does not automatically void it, and we take care to preserve any remaining coverage when a warranty part is the right call. We’re honest about when a repair should go through the manufacturer instead, and we’ll tell you if that’s the case before any work starts.
In Granada Hills, most Linear openers between 5 and 12 years old are well worth repairing if the failure is a capacitor, gear, sensor, or limit switch, because the operator housing and motor are usually still solid. We only recommend replacement when the motor winding itself has failed or the control board is damaged past reliable repair, and we’ll show you the dead part before we recommend anything. You’ll always get a straight repair price first, then you decide.
A properly done Linear gate repair on a well-maintained gate should last years, not months, because we fix the cause of the failure, not just the symptom. Every repair we complete is backed by our 90-Day Done Right Promise in writing. If anything we touched fails inside 90 days, one call brings us back, no runaround.
If your Linear gate in Granada Hills is acting up, call (760) 361-6706 and tell us what it’s doing. We’ll give you a straight answer, a free estimate, and a repair that’s done right the first time.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving Granada Hills and nearby areas.